Wiring Reliefs!

If your running your switches on you bars then I need to cut these reliefs in your bars. Its the equivalant of "Dimples". 

I'll need you to measure from the OUTSIDE of the bars to the END of your grip [were the switch housing and grip meet]. And then again from the END of the bars to the END of your Lever Clamp [total length of your controls]. I try to make it so that you'll have a 1/2in opening once your controls are installed so, accuracy is key.

If your going for INTERNAL WIRING, I just need to know where your switch housing starts and stops measured from the end of the bars. This way the relief cut sits inside your switch housing and can not be seen.


Steffan
Zombie Performance
www.zombieperformance.com